Fire resistance door European standard class EI

Single leaf high fire resistance steel door or flap EI₂120-S_a4-C5 according to EN 16304

labelled

EI₂ 120-S_a4 / E 120 / EW 60 tested according to EN 1634-1

test report WFRC 360408 according to EN 13501-2

• as gate according to DIN EN 13241
• as external door according to DIN EN 14351-1

Combinable with additional performance characteristics:

U_D-value ≥ 2.7 W/(m²K) according to EN ISO 10077-1

RC2 - expert report No. 45-47/22.126, PIV-Velbert
RC1 - expert report No. 45-47/22.126, PIV-Velbert

according to DIN EN 1627 - 1630

up to class 4 according to EN 12207 (± 600 Pa)

up to class C5 according to EN 12210 (± 2.000 Pa)

up to class 8A according to EN 12208 (+ 450 Pa)

according to DIN EN 12211 (up to 5,000 Pa)

class 2 (d + e) according to EN 12219 (deflection)

according to DIN EN 16034
hold-open device according to DIN EN 14637

according to DIN EN 14351-1
proven for doors in escape and rescue routes

flush-mounted design FLAT

leaf thickness 68 mm to 69 mm - smooth double-walled
plate thickness 1.0 mm to 1.5 mm

• thin rebate
  • optional thick rebate
  • insulating insert
    • optional full-face glued and pressed with cover plate,
      thus particularly smooth and even door leaf
• Thelesol® 120 Brandschutzleisten an den Türblattkanten

securing pins

with elastic rubber seal

corner frame

• optional enclosing frame
• optional block frame

• optional lowerable floor seal RSI
• optional time-delayed closing floor seal RSI-V
• optional sliding seal / grinding seal

2/3-part KO door hinges
with patented easy-running bearings as Easy-running doors
or with ball-Bearing spacer rings

• optional door hinge with 3D adjustment

• optional any approved handle set according to EN 1906 resp. EN 179
• optional panic bar handle or push bar according to EN 1125

for RC version: ES-1 to ES-3 security fittings

single locking according to EN 12209, depending on version multi-point locking
profile cylinder prepared (cylinder on-site)

• optional panic locking according to EN 179 resp. EN 1125

door closer according to DIN EN 1154

• optional spring hinge for smaller doors / flaps

• in masonry(thk ≥ 175 mm)
• in concrete(thk ≥ 140 mm)
• in aerated concrete(thk ≥ 150 mm)

• optional blunt installation in soffit
• optional installation on the wall plate

• approved for installation at great heights (installation not at floor level: height on one or both sides > 500 mm above ground level - e.g. as manhole door/flap) with lower fire and smoke seal - also thresholdless

labelling and declaration of performance

• additional security devices possible
  (magnetic contact, bolt contact, e-opener...)
• stainless steel design